Skip to main content

Work in progress

Short status pages for the hardware we are developing right now. They show where each design stands, with renderings, a few simulation results and how it fits into the FRAME. They are not build instructions: designs, numbers and part numbers will still change.

projectwhat it isstatus (November 2026)
openSIM (DLP2000)structured illumination with a small DLP projector, fibre-fed, in the FRAME OPMrev B designed, electronics redrawn
openRAMANcompact Raman spectrometer block, shared with our low-cost OCTprototype: first light, calibration and data collection
LED dome221 addressable LEDs on a foldable flex PCB for illumination from many anglesboard and holder generated
DLP projector in the OPMpatterned light (for example photostimulation) through the FRAME's objectiveprinted case designed, FRAME fit checked
Filter changermotorised linear changer for four complete filter setsrev C designed, LED variant added
Multicolour LEDthree LEDs combined into one cube for fluorescencerev A designed after a first print
DLP4710 LED projectorblue, green or red light patterns through the FRAME's objective, LEDs built inoptics compared in theory; prototype once the module is here
Cube bus contactsspring-pin contacts that connect a cube to the CAN bus and 12 V when it stands on the plateconcept checked against the cube CAD; first test parts in preparation
Markers on cubessmall codes on a cube that tell a camera which module it is and where it standscollection of ideas; first print test planned

Questions or ideas? Write to support@openuc2.com.